In Linear curves I always just took it for granted a lower end than start does not work as one would expect. You'd expect the curve to go down, but to get that you have to check the Invert checkbox.
Since I just ran into a problem with that I was just wondering: is there a reason the Linear curve works like that?
|Posted: November 11, 2008 4:19 pm|
|When the Start value is greater than the End value, they get reversed – the Start parameter defines the End value and vice versa. This is needed to avoid flipping the curve horizontally.|
|Posted: November 12, 2008 6:15 am|
I know that
But why do you want to avoid that?
|Posted: November 12, 2008 6:28 am|
||...to annoy me?|
|Posted: November 20, 2008 8:30 am|
Filter Forge has a thriving, vibrant, knowledgeable user community. Feel free to join us and have fun!
15,510 Registered Users
+14 new last day!
+110 new last day!
+18 new last day!
10 unregistered users.