Filter Forge - Patterns and Noise Non-working tabs

Active Topics Search

CFandM ForgeSmith Posts: 3559 Filters: 204	Don't know if these were disabled due to that multi-threading error such as the cancel buttons but....In the curves section of the Gradients and noise components the dropdown menus for the "Profile" do not pull down....This is also the same for the "Bevels" dropdown menu in the patterns components......... Stupid things happen to computers for stupid reasons at stupid times!
	Posted: October 9, 2011 6:39 am	Details E-Mail
Crapadilla lvl 52 Filter Weaver and Official "Filter Forge Seer" Posts: 4037 Filters: 59	Unable to reproduce. Dropdown menues on noise and pattern components work perfectly here. --- Crapadilla says: "Damn you, stupid redundant feature requests!" ;)
	Posted: October 9, 2011 8:05 am	Details E-Mail
GMM Moderator Filter Forge, Inc Posts: 1726	CFandM, are you using Windows XP? This seems to be an XP-specific issue. We've reproduced it, that's a bug point for you.
	Posted: October 10, 2011 4:41 am	Details E-Mail
CFandM ForgeSmith Posts: 3559 Filters: 204	Yep you are correct sir. I was going to test on 7 but did not have the time to do so... Stupid things happen to computers for stupid reasons at stupid times!
	Posted: October 10, 2011 11:47 am	Details E-Mail