The Checker Component has Controls for repeat H and Repeat V which go down to a minimum setting of 1. (I could call this 2, but 1 is OK)
It would be nice if the sliders would go down one or two setting lower, So that, at least, one square covered the same area as one squareised component (such as a gradient)
The Checker Component could then be used to create edges instead of using perlin noise (which would make GMM very happy.)
|Posted: July 3, 2006 7:23 pm|
It wouldn't work on non square textures. We have an idea for a separate component (or even a set of components) for that purpose.
|Posted: July 4, 2006 7:41 am|
Filter Forge has a thriving, vibrant, knowledgeable user community. Feel free to join us and have fun!
16,191 Registered Users
+5 new last day!
+30 new last day!
+6 new last day!
12 unregistered users.