A minor annoyance about the steps curve: Is there a reason, why the first and last step are halved? More often than not an even distribution would be more helpful.
I can adjust it with start/end, but that's a bit cumbersome.
A bonus would be a check box to start with the first step and end with one before the maximum.
Also having more smoothing options would be nice.
|Posted: April 30, 2012 8:28 am|
|Use the "threshold" to slide shift the curve forward or backward. So then the steps can start at the end or at the beginning.|
|Posted: April 30, 2012 12:32 pm|
Thx, I surely must have played with that, even if I can't remember it.
Still it will either omit 0 or 1, if I haven't overlooked something else.
I ended up using a kludge once more. I attached the snippet, so you can check it out if you want.
Would be a lot easier, though, if one could wire controls and inputs directly with math.
Evenly spaced steps.ffxml
|Posted: April 30, 2012 6:58 pm|
|Nebukadnezar||Of course I was talking about "Stairs" all the time, not steps. -.-'|
|Posted: May 1, 2012 1:23 pm|
And I thought we were going dancing
|Posted: May 1, 2012 1:30 pm|
|Nebukadnezar||Well, that looks kind of problematic, too.|
|Posted: May 3, 2012 4:16 pm|
Filter Forge has a thriving, vibrant, knowledgeable user community. Feel free to join us and have fun!
15,371 Registered Users
+32 new in 7 days!
+101 new in 7 days!
+16 new in 7 days!
Betis, 15 unregistered users.