Filter Forge - Filter causes Strange profile gradient behavior...

Filter causes Strange profile gradient behavior...

pixel8ted Posts: 59 Filters: 65	Here's an odd one. You'll notice in the image that the controls indicate that the Profile Gradient is set to repeat once with 0 offset. The Profile Gradient...and any I pull from the component area...do not, however, go below three repeats with this filter file. I tried Select All and Clear to remove all components but ALL the profile gradients act the same way with this filter...or any built in this filter workspace. The Profile Gradients work as expected if I build in a fresh work area. Here's a screen shot of the offending filter work area with a Profile Gradient displaying this behavior: Terri
	Posted: July 9, 2006 3:20 am	Details E-Mail
pixel8ted Posts: 59 Filters: 65	If I copy all components and put them into a fresh workspace, the profile gradients behave as expected. Terri
	Posted: July 9, 2006 3:51 am	Details E-Mail
onyXMaster Filter Forge, Inc. Posts: 350	Be sure to check the Size slider in filter controls.
	Posted: July 9, 2006 11:36 am	Details E-Mail
pixel8ted Posts: 59 Filters: 65	onyXMaster, Thanks! It was the Size slider in filter controls causing this behavior. Terri
	Posted: July 9, 2006 11:50 am	Details E-Mail

Filter causes Strange profile gradient behavior...