Submit Filter to Libary

I submit a little one Filter in the morning and by the next,
a bigger one, it comes the failed message.
After that i reading a bit in the Forum, but I find nothing what can help me.
I controll all Components, no HDRI-Problems....

So here is my


...is there anybody out there???

mw_Studio Light_Tri.ffxml

I've asked the devs to take a look at your filter.

Hy, GMM!

Quote
Have you by chanced edited the ffxml file manually?

No, i haven´t.

But,
> i sometimes copy & paste components from a other filter who i made
> with this filter was the same problem
> i remember that i had a render-bug with it, i do something wrong to submit this problem
> all this comes together with a pc-bluescreen-crash

for the crash,
> i install for everything new updates
> i made a backup from the Filter-Libary and install Filter Forge new
> copy & past only a handful of Filter back
> and change the CPU-Render to Single Core for a lower charge
> (64bit AMD Duo Core 3,0 / Nividia GTX 560 )

now
> FF runs fine but i have this Filter-Problem only when i try to submit it

I think i will rebuild this Filter as a new one.

Ok, thanks for your help! When i found something, i will let you now.....

Crash Info -> Bluescreen for everyone who was interested in:

my Set:
> Win7 / AMD Athlon 64 X2 6400+ / Nividia GTX 560 / 6GB RAM

the Crash
> my Bluescreen-Crash was a --> dxgmms1.sys <--
> i find out that this is a --> DirectX <-- Problem
> to check it --> dxdiag <-- into command entry field
> and i install DirectX 11 new
> and new Updates for everything

other thing: it can be a RAM-Malfunction

Solution that i found:
> checking Ram with Memtest86+
> for a stable Run you can set the Voltage for the RAM higher (Bios)
> i have much too little know to say what there are the best Se ttings

> i hope it kills all the problems for the future or i must buy something new

for more Info about the own Pc-Setup:
> CPU-Z (Mainboard...) / GPU-Z ( Graphic Card)

for contolling GPU Clock speed, GPU Voltage, Memory Clock speed and Fan speed
> EVGA Precision x 3.0.4 / (evga.com)
> (Nividia Cards. I think for other Cards there are something similar)

I rebuild the Filter 1 to 1 from scatch, but I can`t submit it to the Libary!!!!!
To many Settings??? I had now Crashes with it.
The Filter by itself works fine.

If you could watch over it again, here is the new one:

Hy GMM!
I think i found the Submit Failed Combination in my Filter

I send one with lower Setting and without this Comb as a Test with success!

So can you check this?:

Hy, GMM!
Here is a other one and its similar to the mw_Studio Light_Tri-Filter.
I have tested a lot of combination but i also can't submit it.
I know jet that it has nothing to do with the number of Settings,
because I've already sent some other filter.
The only difference I noticed is, that i use there Math-Combos.
But one further transfer test was not successful.

If you find something let me now!

mw_Studio Light_Led.ffxml

....> Great! i will change it. TX!

Great!
I have updated the mw_Studio Light_Tri with 2.004 Version,
but in my mw_Studio Light_Led - Filter must be a similar issue! It doesn`t run....

The Filter:

mx_Tri Eye.ffxml

Ok, i think i will wait... the filter is almost there...
For the other Filter it will probably be the same?!...thx