UF startup problem fixed

I have a laptop with 2 graphics cards: HD Intel and NVIDIA. The UF test shows:
"Windows version: 10 or higher – Passed.
Vulkan version: 1.3 – Passed.
Free disk space: 617,6 GB – Passed.
VRAM: 8,0 GB – Generative AI nodes may not always work. 8 GB is recommended.
Ultraforge will run on this machine, but its generative AI features may not work or may be limited because the requirements aren’t fully met.
Device 0: Intel® UHD Graphics
Device 1: NVIDIA GeForce RTX 4060 Laptop GPU
Device 2: Microsoft Basic Render Drive"

My laptop has 32GB RAM and 8GB VRAM. Why does the check calculate these values?
"VRAM: 8,0 GB – Generative AI nodes may not always work. 8 GB is recommended." O.K., then I give more RAM for the graphics card via the BIOS. But I couldn't find these settings in the BIOS anymore. On my old laptop I was able to reserve RAM for the HD graphics card. There is no longer.

A UF test with the "KITTY" results in a brown spot. In the diaper control panel APP assigned to high performance = NVIDIA. Test shows a brown spot.
Next attempt via the NVIDIA control panel 3d everything is set to "NVIDIA only". Some programs displayed prevented the switch, I closed them in the taskbar. A UF test with the "KITTY" results in a brown spot. (I'll tell you more later that switching is prevented when the battery is running with a weak battery.)

Now I wanted to go hard and enable “NVIDIA only” in the BIOS. “KITTY” appeared in IF-Test.
Now I no longer work with the BIOS, but with the NVIDIA control and a full battery or mains connection.

I'm excited about the UF full version and am fully expecting to spice up the generated images with filter functions.