The Reverse component flips the source curve horizontally relative to the center of the visible range of the source curve. This is a curve component, it can be located in the Curve Ops category on the Components Bar.
Reverse: Map Input
When turned on, the curve specified by the Source input is flipped horizontally. When turned off, the component has no effect. When a map component is connected to this input, the state of the checkbox is determined separately for different image areas by the brightness level of the image supplied by that component. The brightness level of 0 to 50 corresponds to unchecked Reverse, and the level of 50 to 100 corresponds to checked Reverse.
Source: Curve Input, Required
Supplies the curve to be reversed. This is a required input – to make the Reverse component work, this input must be connected.
